GKTech M12 OEM Length Inner Tie Rod for Nissan 240SX '89-'94 Skyline R32 GTS-T
$31.00
These inner tie rods are an OEM replacement only.
- M12 in size
- Rod is manufactured from HRC 25-28 Steel with PTFE (Teflon) lined maintenance free bearing
- 50 degrees range of motion (25 degrees misalignment)
- Sold individually
Vehicle Compatibility:
- Nissan S13 Silvia
- Nissan 180sx
- Nissan S15 200SX
- Nissan Skyline R32 GTS-T
- Nissan A31 Cefiro
FAQ'S
How hard are these to install?Remove your old tie rods, measure where these need to be cut in length and install them. It's a very self explanatory install and shouldn't take longer than 30 minutes.
Will this fit my car?If your car is listed above then the tie rods will fit however they may also fit other setups not listed but we can't be sure.
Do I need a wheel alignment after installing these?Unless you get the length spot on perfect, you will need a wheel alignment after installation.What thread pitch is the rack end?The M12 Inner tie rod is M16X1 on the end that goes into the steering rack and M12x1.25 on the end that goes into the outer tie rod end.