Wiring Specialties VQ35DE Wiring Harness for S13 240sx - PRO SERIES
$1,025.00
Looking for the best in aesthetics, weight savings and reliability out of your harness? Our Pro Series harness completely replaces your old OEM harness so you can forget about those electrical gremlins.
This Wiring Specialties PRO Series harness was designed from the ground-up to exceed OEM specifications for wire quality, power/ground routing. With our optimized and 'tucked' approach the end result will be a clean and worry free installation with a guaranteed start up.
This harness is specifically engineered for a USDM S13 240sx (89-94) with the 350Z/G35 VQ35DE engine swap. It was developed in house on an actual VQ35DE engine to ensure a perfect fit to all engine connections.
Wiring Specialties offers a number of options for common performance upgrades for this product. Build your perfect harness by selecting from the available options to the right, and as always - if you have any questions, please reach out to us
ENGINE: 350Z/G35 VQ35DE
- REQUIRES use of OEM Smart Coils
- Please check your engine to verify the number of pins on your O2 Oxygen Sensor connectors before ordering
- Rev-Up Engines are NOT supported at this time
- HR or Hi Rev Engines are NOT supported at this time
CHASSIS: LHD USDM S13 240sx
- Any USDM LHD S13 240SX model years 1989-1994 (Including ABS and Convertible cars)
- Factory Tachometer use requires the S13 DOHC SR or KA 91-94 tach to be installed in 1988-1990 CA18 or SOHC KA24E original engine cars.
- Factory Tachometer use requires manual tach adjustment, or use of the Dakota Digital SGi Box W/ Tach Wiring Option unless using an Aftermarket ECU
- Factory Speedometer use with CD009 trans requires a custom GPS Speedo / adapter or the use of ABS or additional aftermarket sensors to provide a speed signal. The CD009 transmission does NOT have a speed sensor.
- AC, reverse lights, wipers, engine temp gauge, Alternator Warning light and Oil Pressure Warning light remain functional.
PRO-SERIES HARNESS INCLUDES
- Main Engine and Transmission one-piece tucked harness
- Alternator charge cable
- 6x Coilpack connections
- 6x Injector connections
- MAFS connector
- TPS connector
- OEM Oxygen sensor connectors - Heated 4-pin or Wideband 6-pin as selected
- Ground ring terminal
- Nissan Diagnostics connector
- Reverse lights sensor connector
- Alternator connector
- Starter signal connector
- Dash and fuse box connections through the Interface harness
- Printable install instructions with pictures
- Turn Key ENGINE START Guarantee
- Tech support for our customers 7 days a week
BUILT TO ORDER - Usually ships in 4-6 weeks