Verus Engineering Backing Plate Kit with Dry Carbon Duct for 2.5" Hose, Set of 2 - FT86

The Verus Engineering Backing Plate kit is constructed from a stainless backing plate for durability and a properly formed and located dry carbon duct that directs air into the center of the rotor. This is a great start to a do it yourself brake cooling kit for FRS/BRZ/GT86s.

Increase endurance, life expectancy, resistance to brake fade, and resistance to boiling brake fluid by hooking up a 2.5" silicone brake hose to these backing plates and running cool air through the rotors.

The backing plates are designed to work with OEM and aftermarket big brake kits, this is a must for those looking to get the most from their brakes. Stainless hardware throughout and hard anodized aluminum spacers ensure the kit will remain rust-free for the life of the units.

Note: In some severe cases the backing plate may need to be trimmed. IE: AP sprint kit with Whiteline roll center adjusters. The lower control arm to rotor clearance is less than the thickness of the backing plate. The AP Sprint BBK will fit without trimming on factory ball joints.

WHAT IS INCLUDED
• Backing Plate with Carbon Duct, Left-Hand Side
• Backing Plate with Carbon Duct, Right-Hand Side
• Hardware Kit, Includes All Necessary Hardware for a Seamless Install
FEATURES
• Carbonfiber Duct Directs Air Into the Center of the Rotor
• Stainless Backing Plate Further Encourages Airflow Into Center of Rotor
• Standard 2.5" Brake Duct Hoses Fit on Duct
SPECS
• Stainless Backing Plate
• Dry Carbon Air Duct
• Hard-Anodized Spacers
• All Necessary Stainless Hardware Included
• Foam for Wheel Sensor Wire Protection
• Made in the U.S.A.