GKTech FR-S / 86 / BRZ SOLID REAR SUBFRAME BUSHINGS
$169.00
The GKTECH solid subframe bushings are a direct replacement of the standard items and ensure that movement of the subframe is kept to a minimum. They eliminate axle tramp whilst also raising the subframe 0.59" (15mm) which helps to correct the roll center on lowered vehicles.
- CNC Machined from 6061-T6 aluminum
- 4 Piece Set + 4 shims to adjust roll center
Vehicle Compatibility:
- Scion FR-S
- Subaru ZC6 BRZ
- Toyota ZN6 GT86
FAQ'S
Will this fit my car?We can only confirm fitment for the vehicles listed above under "vehicle compatibility". If your car is not listed there, then we don't know if it will fit.Do you make these to suit other cars?We only sell the parts listed on our website. If it's not listed on our website, then we don't sell it. Sorry.
What's the advantage of using the GKTech solid rear subframe bushings?The solid bushings offer a more solid rear end which equals to a better driver control and feel for the rear end. The Gktech solid bushings also raise the subframe 7.5mm, improving roll centre correction.
What modifications are required, is this hard to fit?No modifications are required just simply remove and refit the bushings.
Is there anything else needed for installation?No, you can use your OEM hardware. In terms of the bushings themselves, they will arrive as shown in the product photo.
Can I install this myself? If so how long will installation take?Yes, provided you have general mechanical knowledge they are relitively straightforward. Installation time should be around 1 hour once the subframe is out. However, being a suspension component we recommend only a trained professional to install this product.
Do these cause much vibration/noise in the cabin?Not really. Obviously anything solid or more rigid is going to cause an increase in noise and vibration however I'd hardly say that it's noticeable. Chances are if you're installing these you've already got coilovers, your car is lowered, you've got an aftermarket exhaust etc. etc.
Do these bushings change the height of the subframe?Yes, they raise the subframe 7.5mm, which improves roll center.Will I have to get a wheel alignment after installing these?Considering the subframe has been removed and refitted 7.5mm higher, this will change your alignment. If any suspension changes are made we do recommend a wheel alignment.Which way are these bushings suppose to be fitted?When looking at the subframe in the car, they are to be fitted from the bottom (ground) to the top (chassis). If they were to be fitted the other way around the subframe would possibly fall out.