Megasquirt 50mm Optical Trigger Wheel for Nissan SR20DET or KA24DE
$29.00
Convert your Nissan CAS to a more MegaSquirt-friendly arrangement with our bolt-in 50mm Nissan Trigger wheel! This replaces the stock low-resolution Nissan trigger wheel that has four slits with a higher resolution 24-2 wheel crank trigger. Intended for use with MS1, MS2 or MS3. (MS3 has experimental support for the stock CAS however this will still provide higher resolution ignition timing!). This is intended for use on the following Nissan motors, in alphabetical order:
- GA16DE
- KA24E (Note: Some KA24Es use a 54 mm trigger wheel; please check before ordering.)
- KA24DE
- SR20DE (Note: Some FWD applications used a 54 mm trigger wheel; please check before ordering.)
- SR20DET (Note: Some FWD applications used a 54 mm trigger wheel; please check before ordering. All RWD versions are believed to be 50 mm.)
These may also direct fit to other Nissan, Mitsubishi, and Suzuki crank angle sensor applications. Look for a 50mm outer diameter with a D-shaped hole in the center. Does not fit most RBs, VG, or CA motors. Distributor equipped engines can gain extra resolution and more precise timing, while cars with coil on plug can now use MegaSquirt without having to add a crank trigger. Easy bolt-on installation, just take the cover off your CAS or distributor, remove the rotor on a distributor, and undo the big Philips screw in the middle. Once you’ve got that, it just drops in.