HKS V CAM SYSTEM SYSTEM STEP Pro (VALCON LESS KIT] for Nissan RB26

The favored HKS V-CAM system for RB26
without VALCON type is newly launched.

RB26 V CAM SYSTEM
(VALCON LESS KIT]

Kit includes * HKS V-CAM system with VACLON type for
RB26 sold separately.
• Special V-CAM shaft
• Variable valve timing unit (Vane type controller for
high torque. Pulley with nickel plating.)
• Intake side special cylinder head cover. (HKS
original casting product. No paint. Includes special
logo plate.)
• V-CAM sensor harness. (F-CON V Pro 3.4
connected terminal)
• Oil control valve (Electromagnetic)
• Cam angle sensor (Highly accurate type)
• Oil lines (between the hydraulic take-out section of
the engine side and the cylinder head cover.)
• Other parts

Opening Degree 264 degree

Billet hollow cam. Separate purchase of the HKS forged piston kit is necessary. A polished cylinder surface or using a thin gasket may cause insufficient clearance between the valve and the piston.

Variable Valve Timing
Control Unit F-CON V Pro ver. 3.4 or VALCON type RB26

CAM Shaft (EX) STEP 2 (272° or above)

Valve Spring Stock: Recommends HKS enhanced parts (If increasing allowable rotating speed)

Piston: HKS Piston (To secure the clearance between the valve and the piston)

Oil Pump: Recommends HKS enhanced parts

Engine Oil: Recommends HKS SUPER TURBO RACING 15W50 or HKS Racing Pro 10W50

Timing Belt: Inspect the wear or tension each drive 10,000 km. Adjust them if necessary.

Other: The valve timing may not reach the target value due to insufficient hydraulic pressure when the viscosity is low. It cannot have an advanced angle when the water temperature of 60 degrees or lower.

Compatible the stock piston. Surface polishing on the cylinder or using a thin gasket may cause insufficient clearance between the valve and the piston.