MS3Pro PNP Plug and Play ECU for Ford Mustang 5.0 V8 '94-"95 SN95

The NEW SN95 Ford Mustang MS3Pro PNP ECU Plug and Play Standalone Engine Management System is compatible with the following:

1994-1995 Ford Mustang 5.0 with manual transmissions! Easy to Use and Install!   

MegaSquirt MS3Pro Plug and Play/PNP ECU for the 1994 & 1995 SN95 Ford Mustang Features:

• Fully Plug and Play Installation – No wiring required for basic functionality.
  
  • Average install time is under 1 hour!
• 5.0 HO base maps pre-loaded to help your engine start on the first turn of the key
• Real time tuning and data logging with a laptop connection
• 8 GB internal data logging with built in SD card
• Supports most aftermarket wideband sensors/controllers
• Factory tachometer control

Does your speedometer read incorrectly due to a gear ratio or tire size change?  NOW you can easily fix it in TunerStudio and save a costly trip to your tuner!

Fully Tunable Engine Control for your SN95 Mustang!

• 16×16 Fuel Tables allow high resolution tuning
• 16×16 Ignition Tables
• Multiple Acceleration enrichment strategies
• Closed Loop Idle Speed Control
• Air Conditioner Control
• 8 sequential fuel injector channels with individual trim tables
• 4 wasted spark ignition channels with support for sequential coil on plug conversion
• Onboard high impedance injector drivers
• Allows removal of stock MAF sensor

Advanced Feature Set 

• 12×12 Air Fuel Ratio Target Tables for use with wideband O2 sensor for precise tuning and table trim.
• Multiple traction control strategies
• Built-in 3-step rev limiter / launch control with flat shift and burnout rev limiter
• Time based timing / boost increase after launch
• Real time barometric correction
• Internal 4-bar MAP sensor reads up to 44PSI of boost
• Configurable engine safties, warning lights & overboost protection
• Closed loop boost control
• CO2 based boost control
• Set boost by RPM and throttle, ground speed, or gear
• Nitrous control strategies
  • 2 channels of configurable staged or progressive control
  • Supports wet or dry nitrous systems
  • Add fuel, pull timing, etc.
• Rally style anti lag
• Water injection control – on/off or variable
• Knock sensor input with adjustable sensitivity, crank angle windowing, and more
• Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
• Input for flex fuel sensor – switch between E85 and gasoline on the fly!
• Supports many aftermarket dashes/displays such as Racepak, Race Technologies, AiM Sports, AEM, Dakota Digital, Autosports Labs, Perfect Tuning, etc.
• CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors…..the possibilities are limitless!

What you get in the box:

• 1994-1995 Ford Mustang SN95 MS3Pro Plug and Play/ PNPECU
• RS232 tuning cable
• 8GB USB Drive including:
  
  • Registered version of TunerStudio and MegaLog Viewer
  • Hardware Documentation & Base Map
• 6′ Vacuum Hose for MAP Signal and ‘T’ fitting