Anderson Composites HOOD CHEVROLET CAMARO 3 INCH COWL 2010-2015

Anderson Composites VIP carbon fiber parts are manufactured by spraying a coat of resin on the mold, sheets of carbon fiber fabric are laid out across the mold and then a final coat of resin is applied on the fabric before being placed inside a vacuum sealed bag to cure (provides an excellent fabric-to-resin ratio). Once cured, the part is removed from the mold, trimmed and a final coat of gel coat applied and polished to protect the surface and increase the high luster finish. No additional clear coat is required.

Anderson Composites 2010 - 2015 CAMARO TYPE-COPO FIBERGLASS COWL HOOD

Type-CP (COPO style) fiberglass hood with 3 inch cowl for 2010-2015 Chevrolet Camaro

*Also fits 2014-2015 (hood has 2010-2013 body line in center of hood)

*Mounts with OE hardware, hinges and latch

*Does not have a provision for the OE windshield washer nozzles and hose.

*Fiberglass hood (A side) bonded to fiberglass "skeleton" (B side)

*Do not push hard on surface when sanding. Do not bake with paint curing lamp, allow to cure with ambient air temperature.

*All hoods require hood pins for safety reasons. Anderson Composites will not be liable for any damages to the product and the vehicle caused by not properly using hood pins- AeroCatch or Quic-Latch

*Heat shield required

*Always carefully close a composite hood. Slamming or dropping the hood may cause it to crack.

*Anderson Composites does not suggest re-installing gas shocks/dampers/struts

*The use of a hood prop rod is highly recommended

* Hand crafted; approximate weight 25.4 lbs.