Anderson Composites HOOD FORD MUSTANG TYPE-CJ 2013-2014

Anderson Composites VIP carbon fiber parts are manufactured by spraying a coat of resin on the mold, sheets of carbon fiber fabric are laid out across the mold and then a final coat of resin is applied on the fabric before being placed inside a vacuum sealed bag to cure (provides an excellent fabric-to-resin ratio). Once cured, the part is removed from the mold, trimmed and a final coat of gel coat applied and polished to protect the surface and increase the high luster finish. No additional clear coat is required.

Anderson Composites TYPE-CJ CARBON FIBER COWL HOOD FOR 2013-2014 FORD MUSTANG

Type-CJ carbon fiber 3 inch cowl hood for 2013-2014 Ford Mustang
-Outside diameter cowl height measured where hood meets windshield

*Mounts with OE hardware, hinges and latch

*Carbon fiber hood (A side) bonded to fiberglass "skeleton" (B side)

*Requires hood pins for safety reasons

*Heat shield required

*Always carefully close a composite hood. Slamming or dropping the hood may cause it to crack.

*Anderson Composites does not suggest re-installing gas shocks/dampers/struts

*The use of a hood prop rod is highly recommended

*Modifications may be necessary for correct fitment of the O.E. windshield washer spray nozzles and fluid lines as part of the normal installation process

* Hand crafted; approximate weight 23 lbs., (stock hood weighs 32 lbs.)