SLR Speed RX-7 FC Drift Kit Purple
$724.90
This is a 100% bolt on solution*. Made from high quality billet 7075, then anodized for long lasting protection, assembled with top quality bearings & rod ends and machined CAD plated ball-joint studs. All built in the USA.
The kit features:
Bolt-on* double sheer control arm extensions to increase track width 50mm oer side (+100mm overall) for wheel and tire clearance
Allows for up to 60° of steering angle, wheel/tire size & offset dependent
High quality impact resistant tie-rod ends
40% quicker steering ratio over factory
Quick four position Ackerman adjustment allows you to tune your setup for each track and driving style.
35mm of roll-center correction improves front end geometry on lowered cars
Bump steer corrected outer tie rod end with billet aluminum tie rod extension tubes, allows use of factory style inners.
All hardware included for quick and simple bolt-on installation.
Compatibility: Will require use of the Series 4 (S4) '85-'88 front control arms. They use a bolt-on front ball-joint which this replaces.
*Power Steering Rack only