TOMEI Valve Springs Type A - Nissan SR20DET
$180.00
Tomei began operations in 1968 as a race car tuner in Japan. Over the last 40 years Japan has emerged as one of the leaders in automotive research racing and culture. Tomei products have been utilized in nearly every motor sport imaginable. Tomei’s racing heritage means their research and design team have first hand knowledge of the extreme demands racing puts on an engine. Using only the highest quality materials means that Tomei’s products can handle the intense strain and heat a purpose built engine will experience whether it be on the street or the track. Tomei’s attention to detail is second to none. All of their products are thoroughly researched and engineered to achieve optimal efficiency. Because of even miniscule differences in measurements can cause catastrophic engine failure all Tomei products fall within strict tolerances. Tomei machines all of their engine components to enhance airflow and ensure proper fitment and seal.
High quality springs are required to transfer the exact movement of the camshaft to the valves at high engine speeds this is especially important on high performance engines. Tomei products are always engineered with precision to suit the users needs. This requires careful selection of materials and surface coating. Tomei springs are constructed with oil tempered chromium-silicone alloy steel wire which is considered to be the best material for performance springs in the industry. These high quality materials combined with a new optimized design means the springs are more durable as well as more effective at suppressing valve jumps or bounce even at high RPM’s. The nitrogen surface treatment permeates the spring and gives it increased surface compression repulsion. This method was chosen to raise the fatigue limit to suit the high RPM deamands as well as running high lift camshafts. The dangers of spring failure is greatly reduced with the 1.5 times increase in the springs fatigue limit with the combined use of Oil tempered chromium-silicone alloy steel wire and nitrogen surface treatment. This allows Tomei springs to be used on engines that rev to 10000 RPM which had not been previously possible with high lift camshafts.
Please select valve spring type above and refer to the diagram below for spring specifications.
LEGAL IN CALIFORNIA ONLY FOR RACING VEHICLES WHICH MAY NEVER BE USED OR REGISTERED OR LICENSED FOR USE UPON A HIGHWAY