Stack 85mm Electronic Racing Speedometer

Price

$412.54

Description

Matching our range of Professional Stepper Motor and Pro-Control gauges...

Key Features:

Fully user programmable.
LCD odometer with a re-settable trip displays.
Maintenance free through the dial white LED backlighting.
LED illuminated needle for maximum visibility.
80mm visible dial dimension, requires 85mm cutout .
Available in black or white dial faces.
Optional sensors available for some cable-drive applications.
Configurable for all negative earth ignition systems and magneto ignition systems.
12 months Competition Warranty.
Supplied with manual.

Professional Speedometer

Stack’s new Speedometers ("speedos") match our range of Professional Stepper Motor and Pro-Control gauges. Simple wiring connections and easy to use push button programming make installation and calibration a snip.

Compatible with most OEM vehicle speed sensors, as well as aftermarket speed pulse generators.

The instrument includes back-lit Odometer and two resettable Tripmeter displays.

Specifications

ST3801	0-160 MPH/0-260 km/h	Black dialface
ST3851	0-160 MPH/ 0-260 km/h	White dialface
ST3802	0-260 km/h	Black dialface
ST3852	0-260 km/h	White dialface

Dimensions

Please note: speedometer requires 85mm mounting aperture.

Speedometer Dimension Drawing

Full mounting, installation and operational instructions can be found in the Speedometer manual (please complete e-form and select appropriate manual).

Frequently Asked Questions

Q. Is a speed sensor included with the Speedometer?

A. No, but it has been designed to work with most OEM vehicle speed sensors and aftermarket speed pulse generators on the market today.

The speedometer is designed to operate with an electrical speed sensor. The speed sensor signal range must be between 310 and 248,500 pulses/km (500 and 400,000 pulses/mile). Any speed sensor or electronic module that meets the following two conditions can be used:

1. Pulse rate generated is proportional to vehicle speed.
2. Output voltage within the ranges listed below:
• Hall effect sensor, 3-wire (5 to 16V)
• Sine wave generator, 2-wire (1.4 VAC min.)
• 5V Square wave (CMOS)

Q. How do I calibrate my speedometer?

A. To calibrate your electronic speedometer (MPH models only):

1) With the power off, push and hold the calibration button (trip/reset button when equipped). While holding the button, start the vehicle and continue to hold the button until the pointer sweeps to full scale and stays at full scale. You may now release the button.
2) Drive to the beginning of a pre-marked 2 mile (or 2km for km/h models) distance and come to a stop. It does not matter how far away it is to get to this pre-marked 2 mile/2 km distance. Do NOT shut the engine off. Push and release the button. The pointer will drop to half scale.
3) Drive the 2 mile/2 km distance. The pointer will remain at the half scale mark no matter what speed you drive. If the speedometer has a LCD display odometer, it will be normal to see it counting rapidly as it is receiving a speed signal. If you have to stop during the calibration, that is alright. The speedometer is simply counting pulses during this time.
4) At the end of the 2 mile/2 km distance, come to a complete stop and push and release the button. The pointer will drop to 0 and the calibration is stored. You are now finished.
Remember the accuracy of your 2 mile/2 km distance will directly affect the accuracy of your speedometer.

Further information can be found in our Troubleshooting Knowledgebase and FAQ sections.

Legal only for use in competition vehicles which may never be registered, licensed, and/or used on public streets or highways; and also for use in other exempted vehicles.

Manufacturer

Autometer

Item number

4913